diff --git a/_source/_posts/2024-05-01-cosmac.markdown b/_source/_posts/2024-05-01-cosmac.markdown
index cd9a113..e73c526 100644
--- a/_source/_posts/2024-05-01-cosmac.markdown
+++ b/_source/_posts/2024-05-01-cosmac.markdown
@@ -36,3 +36,44 @@ Grain #500 sandpaper -> steel wool -> acetone
 
 Looking for a laminator...
 
+Laminator (Pavo Vancouver A4) / parchment paper : utter failure, almost no transfer at all
+
+:check: **Great** result with stickers backing sheet + cloth iron (max temp) + lots of pressure
+* press for 2 minutes without moving iron much
+* shift weight to distribute pressure
+* high pressure finish over details (iron side/tip)
+
+Reference: [Youtube](https://www.youtube.com/watch?v=haqP8xhsYas&t=600s)
+
+Fix broken traces with Lumicolor permanent marker
+
+:warning: Missed a broken trace
+
+## Etching
+
+Etchant solution:
+* 50 mL 23% hydrochloric acid
+* 50 mL 12% hydrogen peroxide
+
+Etches in a few minutes. **Reaction is exothermic.**
+*Don't take it out too early.* The protection by toner and marker both work well.
+
+# Soldering
+
+Checking regularly for continuity, expected resistance values, and absence of shorts was key to success.
+
+# Debugging
+
+System worked on first try except for LOAD mode flip-flop.
+The 4027 from AliExpress behaves in a weird way, as though J and K were reversed.
+
+The expectation is:
+* ~DMA-IN is cabled to ~Q (i.e. the active low DMA IN signal is inactive when Q=0 ~Q=1)
+* at startup Q=0 ~Q=1
+* upon a raising edge of CLOCK, the flip flop transitions to Q=1 / ~Q=0 / DMA IN is active
+* upon a positive signal on RESET, the flip flop transitions to Q=0 / ~Q=1 / DMA IN is inactive
+
+According to both the truth table and the circuit design, this is the behaviour that should be observed with J=1 K=0.
+In practice this is the behaviour observed with J=0 K=1.
+
+If I set J=1 K=0 and set Q=1 by presenting a positive signal on SET, then on a raising edge of CLOCK I see the flip flop going to Q=0 ~Q=1.
\ No newline at end of file